SICK DL100 Pro - PROFINET IO High Feature - Operation Via Ethernet (Ethernet Interface); IP-Network Configuration; Ethernet Parameter List; Device Information

Operation via Ethernet (Ethernet interface)
56 © SICK AG • Subject to change without notice • 8021823/126P/2018-12-17
9 Operation via Ethernet (Ethernet interface)
The distance measuring device DL100 Pro is equipped with two Ethernet
interfaces. They serve communication via PROFINET IO and diagnosis and
parameterization via SOPAS ET. The two interfaces have equal priorities
and are internally connected to one switch.
NOTE!
The conguration program SOPAS ET can be downloaded
from "www.sick.com".
NOTE!
Parameters congured by Ethernet (SOPAS ET) are over-
written with the PROFINET IO parameters once the device
is integrated into a PROFINET network.
9.1 IP-networkconguration
IP-networkconguration–
deliveryconguration
The distance measuring device is delivered with the following IP-network
conguration:
• IP address: 192.168.100.236
• IP network mask: 255.255.255.0
• Standard gateway: 0.0.0.0
InvalidIPnetworkconguration IfthesystemdetectsaninvalidIPnetworkcongurationthenthedelivery-
statecongurationisusedinstead.
9.2 Ethernet parameter list
9.2.1 Device information
Field "Device information"
Parameter Description
Device type Display of the device type
Read/Write access
• Read only
Serial number Display of the device's serial number
Read/Write access
• Read only
Table 23: Page "Device information" – eld "Device information"