14 FLOWSIC600-XT · Operating Instructions · 8018846/1BHP/V2-1/2021-05 · © SICK Engineering GmbH
Important information
Subject to change without notice
1.4.2 Correct use
▸
Only use the FLOWSIC600-XT as described in these Operating Instructions. The manu-
facturer bears no responsibility for any other use.
▸
Do not carry out any work or repairs on the FLOWSIC600-XT not described in these
Operating Instructions.
▸
Do not remove, add or change any components in or on the FLOWSIC600-XT unless
such changes are officially allowed and specified by the manufacturer. Otherwise:
– Any warranty by the manufacturer becomes void
– The FLOWSIC600-XT can become dangerous
– The approval for use in potentially explosive atmospheres is no longer valid
– The approval fur use in lines pressurized above 0.5 bar (7.25 psi) bar is no longer
valid.
1.4.3 Danger identification on device
The following symbol draws attention to important hazards directly on the device:
▸
Consult the Operating Instructions in all cases where the symbol is attached to the
device or shown on the display.
1.4.4 Special local conditions
▸
Follow all local laws, regulations and company-internal operating directives applicable at
the installation location.
1.4.5 Retention of documents
▸
Keep these Operating Instructions available for reference.
▸
Pass these Operating Instructions on to a new owner.
To Next Page
Loading...
Need help?
General
