SICK safeVisionary2 - 2 Safety information; 2.1 General safety notes

2 Safety information
2.1 General safety notes
Product integration
DANGER
T
he product can not offer the expected protection if it is integrated incorrectly.
b
Plan the integration of the product in accordance with the machine requirements
(project planning).
b
Implement the integration of the product in accordance with the project planning.
Laser class 1
CAUTION
If an
y operating or adjusting devices other than those specified in this document are
used or other methods are employed, this can lead to dangerous exposure to radiation.
b
Only use the operating or adjusting devices specified in this document.
b
Only follow the methods specified in this document.
b
Do not open the housing, except for the purposes of the installation and mainte‐
nance work specified in these operating instructions.
LASER
1
Figure 1: Laser class 1
T
his device complies with the following standards:
•
IEC60825-1:2014
•
21CFR1040.10 and 1040.11, except compliance with IEC60825-1:2014, as
described in Laser Notice No.56 dated May 8, 2019
The laser is eye-safe.
Mounting and electrical installation
DANGER
D
eath or severe injury due to electrical voltage and/or an unexpected startup of the
machine
b
Make sure that the machine is (and remains) disconnected from the voltage
supply during mounting and electrical installation.
b
Make sure that the dangerous state of the machine is and remains switched off.
SAFETY INFORMATION 2
8025919/1I9E/2023-01-09 | SICK O P E R A T I N G I N S T R U C T I O N S | safeVisionary2
9
Subject to change without notice