SICK safeVisionary2 - 5 Mounting; 5.1 Mounting the heat sink; 5.2 Mounting the device

5 Mounting
5.1 Mounting the heat sink
Approach
Figure 27: Mounting the heat sink
b
Scr
ew the heat sink into the M5 threaded holes located at the side.
b
Maximum depth of engagement: 5.5mm.
b
Tightening torque: 2.5Nm.
b
In case of strong vibrations, use screw locking devices to secure the fixing screws.
Complementary information
If y
ou are using heat sinks, then only the threaded holes on the bottom of the device
are available for mounting.
Further topics
•
"Pr
otection from overheating", page 23
•
"Heat sink", page 100
•
"Dimensional drawings", page 97
5.2 Mounting the device
Overview
Y
ou can use either the threaded holes at the sides or the threaded holes at the bottom
of the device for direct mounting.
Prerequisites
•
Pr
oject planning is completed.
•
Assembly is carried out according to the project planning.
•
Dangerous condition of the machine is and remains switched off during mounting.
•
The outputs of the device do not affect the machine during mounting.
MOUNTING 5
8025919/1I9E/2023-01-09 | SICK O P E R A T I N G I N S T R U C T I O N S | safeVisionary2
51
Subject to change without notice