20
8017171/115Z/V3-0/2019-01| SICKO P E R A T I N G I N S T R U C T I O N S | VISIC100SF
Subject to change without notice
INSTALLATION
3 Installation
3.1 Protective measures for assembly and installation
3.2 Material required for assembly and installation
Table 1: Assembly material
Table 2: Installation material
NOTE: Preventive measures for operating safety
The VISIC100SF is normally used together with control technology.
▸ Should a malfunction occur on the VISIC100SF, ensure this cannot lead to
conditions dangerous for traffic or can hinder traffic.
NOTE: The system operator is responsible for the operating safety of the
device when integrated in a system
▸ Observe the connection values, see “Technical Data”, page 103, when integrating
the device in a system.
WARNING: Preventive measures during assembly and installation
▸ Observe the generally applicable regulations for protective clothes in tunnels.
▸ Observe the regulations for personal safety (e.g., lane closure, warning devices).
NOTE: Assembly of the VISIC100SF may be carried out by competent persons
only who, based on their device-specific training and knowledge of the device
as well as knowledge of the relevant regulations, can assess the tasks given
and recognize the hazards involved.
NOTE: SICK original assembly material is recommended for safe assembly of
the VISIC100SF.
CAUTION: The terminal box and TAD control unit do not have independent
main power switches.
▸ In accordance with EN 61010, the following must be ensured before installation:
● A main power switch is available in the tunnel.
● Service personnel can easily access the main power switch.
● The main power switch is marked as disconnecting device.
Material required Part number Required for
Mounting kit 2071034 VISIC100SF, terminal box or TAD control unit
see “VISIC100SF drilling plan (all units of mea-
surement in mm)”, page 100.
see “Terminal box for VISIC100SF dimensions
(all units of measurement in mm)”, page 100.
Drilling plan
Drilling template
Material required Part number Required for
Line, 2 m (12 x 0.75 mm
2
) 2076476
Analog lines for connection of VISIC100SF -
terminal box or TAD control unit.
Line, 5 m (12 x 0.75 mm
2
) 2076477
Line, 10 m (12 x 0.75 mm
2
) 2076478
Line, 20 m (12 x 0.75 mm
2
) 2076479
Onsite lines
Robust material, suitable for outdoor applications,
halogen-free, screened;
wires 12 x 0.75 mm
2
;
Connection VISIC100SF to terminal box, TAD control
unit or tunnel control room.
To Next Page
Loading...
