74
8017171/115Z/V3-0/2019-01| SICKO P E R A T I N G I N S T R U C T I O N S | VISIC100SF
Subject to change without notice
MENU NAVIGATION TAD CONTROL UNIT
6.6 Activating Maintenance mode
The VISIC100SF is set to maintenance mode in the “Maintenance” menu item.
This is required for:
● Maintenance work
● Function check with the VIS filter
● Function check of the gas cells with test gas
Fig. 64: Switching the maintenance signal on/off
After the maintenance signal was activated, “Status
Maintenance” is shown in the status bar. This status remains active for 30 minutes. All
menu items remain accessible and executable.
Maintenance mode is terminated by setting the maintenance signal to “Off” or restarting
the device.
/Maint/
Off
On
Off
On
Menu
Status: Measuring
1 Maintenance
2 Diagnosis
3 Configuration
Maint. Signal 1
Save
Maint. Signal
XXXX
Password
Status: Measuring
Status: Measuring
Enter
/
Login
Back
Back
/Maint/
Back
Password input, see “Changing numerical parameters (password input)”, page 73.
The four-digit password “1234” is predefined at the factory.
To Next Page
Loading...
