51
8017171/115Z/V3-0/2019-01/ SICK OPERATING INSTRUCTIONS | VISIC100SF
Subject to change without notice
VISIC100SF MENU NAVIGATION
5.3 “SET” mode
“SET” mode serves changing VISIC100SF settings.
Navigation in “SET” mode
1 Switch from “RUN” to “SET” mode: Press “Set” for 2 seconds when in “RUN” mode for
any component being displayed.
2 “SET” mode is now active with menu item “Maint”.
3 Use the arrow keys to scroll through the menu until the desired menu item is reached.
4 Press “Set” to access the submenu items.
5 Use the arrow keys to scroll through the submenu items.
6 Press “Set” to activate or change a submenu item.
7 Use “Esc” to exit the submenu or main menu items.
The VISIC100SF may be operated by competent persons only who, based on their
device-specific training and knowledge of the device as well as knowledge of the
relevant regulations, can assess the tasks given and recognize the hazards involved.
NOTICE: Incorrectly set parameters can lead to unsafe operation of
VISIC100SF.
After a parameter change, check the newly set parameters. Ensure that the new
parameters are set correctly.
SET
Maint
>
>
...
...
RUN
X
XXX
Set
Esc
2 s
SET
Status
>
>
Esc
Set
Set
The device switches automatically to “RUN” mode when no user action is registered for
10 minutes. The background lighting goes off.
To Next Page
Loading...
