SICK VISIC100SF - 4 Operation; Operating and Display Elements; Display with Keypad in VISIC100 SF; Reset Button and Maint LED

46
8017171/115Z/V3-0/2019-01| SICKO P E R A T I N G I N S T R U C T I O N S | VISIC100SF
Subject to change without notice
OPERATION
4Operation
4.1 Operating and display elements
4.1.1 Display with keypad in VISIC100SF
VISIC100SF display and keypad
Menu items
● Measuring screen, see “Displaying measured values”, page 47.
– Visibility
–CO
–NO
–NO
2
– Contamination
– Temperature (optional)
● Status information
● Software version
● Operating time display
● Device address assignment
● Inputs/outputs test
● Assignment of analog inputs and outputs
● Activate/deactivate temperature sensor
● Activate/deactivate heating
4.1.2 Reset button and “Maint” LED
The Reset button restarts the VISIC100SF.
Fig. 32: Position of Reset button and “Maint” LED on circuit board
RUN
k
4.5
Esc
2 3
4 5 6 7
Current operating mode
Measured component displayed
Measured value of component displayed
Arrow button to scroll down in the menu
Arrow button to scroll up in the menu
Set button to activate functions
Escape button to exit a menu item
<
Set
<
Esc
1
The display lighting goes on when a button is pressed. The lighting goes off 10 minutes
after the last button was pressed.
More information on menu navigation can be found in Section “Menu”, see
“VISIC100SF menu navigation”, page 49.
2
1
 Maintenance LED
 Reset button