SICK VISIC100SF - Measuring Operation Mode RUN

50
8017171/115Z/V3-0/2019-01| SICKO P E R A T I N G I N S T R U C T I O N S | VISIC100SF
Subject to change without notice
VISIC100SF MENU NAVIGATION
5.2 Measuring operation mode “RUN”
Inquire the current measured values in active measuring operation.
Fig. 33: “RUN” mode overview
>
>
>
>
RUN
CO
XXX
>
>
>
RUN
con XX%
RUN
k
XX.X
RUN
NO
XXX
>
RUN
T XXX
>
RUN
NO2 XXX
Set
Set
Set
Set
>
>
>
Set
Set
NO2 = NO
2
concentration
XXX = placeholder for measured value
● Value ≥ 10: NO
2
XXX
● Value <10: NO
2
X.X
con = contamination/soiling
XXX = placeholder for measured value
● Value ≥ 10: conXX%
● Value <10: conX%
T = temperature
XXX = placeholder for measured value
● Value ≥ 10: T XX
● Value < 10: T X
● Value < 0: T -X
● Value ≤ 10: T -XX
CO = CO concentration
XXX = placeholder for measured value
● Value ≥ 10: CO XXX
● Value <10: CO X.X
Without TAD
With TAD (with activated dust
concentration)
k = visibility
XX.X = placeholder for
measured value
● Value ≥ 10: k XX.X
● Value < 10: k X.XX
μg = visibility
XX = placeholder for measured
value
● Value ≥ 0: μg XXXX
NO = NO concentration
XXX = placeholder for measured value
● Value ≥ 10: NO XXX
● Value <10: NO X.X
NOTE: When the dust concentration in the TAD control unit is activated, k
becomes μg
For representation of visibility in μg, the value in the VISIC100SF display is not output as
K-value but as μg.
The transmitted measuring range in μg is 0 to 1500μg.