SICK VISIC100SF - Measuring Screen

71
8017171/115Z/V3-0/2019-01/ SICK OPERATING INSTRUCTIONS | VISIC100SF
Subject to change without notice
MENU NAVIGATION TAD CONTROL UNIT
6.5.2 Measuring screen
List display and bar chart
Fig. 58: Measuring screen as a list
Fig. 59: Measuring screen as a bar diagram
POWER
FAILURE
MAINTENANCE
REQUEST
MEAS
k
Verschm
CO
NO
Temp
2.63 1/km
3 %
114 ppm
45 ppm
28 °C
Menü
NG
Status: Measuring
Only installed gas sensors are shown on the display.
The temperature is displayed when a sensor was installed and parameter “Temp. on”
has been set.
POWER
FAILURE
MAINTENANCE
REQUEST
MEAS
k
0
3.0
15
100
1/km
Cont.
0
20
%
Menü
Status: Messen
Options Action
Selecting a different measuring screen:
▸ Touch “MEAS” until the desired measuring
screen is displayed.
Switching the measuring component: ▸ Touch / .
Switching to the menu:
▸ Select “Menu”.
When a measured value blinks or an error or a
maintenance request exists.
▸ Select “Diag”.
The list display is automatically displayed after switching on.