SICK VISIC100SF - Retrieving Device Information with Device Info; Retrieving the State of Peripheral Equipment with Submenu Item Peripheral

77
8017171/115Z/V3-0/2019-01/ SICK OPERATING INSTRUCTIONS | VISIC100SF
Subject to change without notice
MENU NAVIGATION TAD CONTROL UNIT
6.7.3 Retrieving device information with “Device Info”
The following device information can be retrieved under this menu item:
● Ser-No.: The serial number is shown with an 8-digit number.
● SW-Ver.: The software version is shown with a 7-digit product number.
● SW-Rev.: The revision index of the software version is shown with 4 characters. It can be
numerical and/or alphabetical.
● SW CO, SW NO and SW NO
2
: The software versions of the installed gas sensors are
shown numerically.
Fig. 68: Retrieving the device information
6.7.4 Retrieving the state of peripheral equipment with submenu item “Peripheral”
This menu item allows to check whether the following peripheral equipment has been
activated:
● CO Sensor
● NO Sensor
● NO
2
Sensor
● Heating
● Temperature probe
● DO Module
● AO Module
Fig. 69: Retrieving the status information of the peripherals (example)
1 Ser-No. 00000000
2 SW-Ver. 9206196
3 SW-Rev. 0000
4 SW-CO 32
Status: Measuring
/Diag/Info/
Back
Device Info
Enter
Status: Measuring
Diagnosis
1 Uptime
2 Device Info
3 Peripheral
4 Messages
/Diag/
Back Enter
1 CO Sensor inactive
2 NO Sensor active
3 NO
2
Sensor inactive
4 Heating inactive
Status: Measuring
/Diag/Peri
Peripheral
Back
The status of the peripheral equipment cannot be changed in this menu item.