SICK VISIC100SF - Setting the Modbus Address in MB ID; Setting the Modbus Data Transfer Format with Menu Item MB Par

58
8017171/115Z/V3-0/2019-01| SICKO P E R A T I N G I N S T R U C T I O N S | VISIC100SF
Subject to change without notice
VISIC100SF MENU NAVIGATION
5.5.2 Setting the Modbus address in “MB ID”
The device address can be entered in menu item “Bus”, submenu item “MB ID” when the
device is connected as “slave” in a Modbus system. The address range is between
0 ... 247.
Arrow buttons: Increase and decrease the digits.
“Set” button: Activate next digit. All digits must be confirmed. Call up the menu again to
recheck the entry.
Fig. 41: Entering the device address
5.5.3 Setting the Modbus data transfer format with menu item “MB Par”
Submenu item “MB Par” serves to set the Modbus protocol parity:
● 1 start bit, 8 data bits, 1 stop bit, even parity (Even)
● 1 start bit, 8 data bits, 1 stop bit, odd parity (Odd)
● 1 start bit, 8 data bits, 1 stop bit, no parity (No 1 SB)
● 1 start bit, 8 data bits, 2 stop bits, no parity (No 2 SB)
Fig. 42: Setting the Modbus protocol parity
RUN
X
XXX
Set
SET
Maint
Esc
Set
>
>
SET
MB ID
Esc
Set
2 s
xxx
>
>
... ...
SET
Bus
Set
>
>
-n +n
»
»
1.
2.
Set
3.
xxx
»
»
4.
1. - 3.
Esc
When the bus address has been entered completely, pressing “Set” switches the menu
back directly to the “Bus” main menu. The setting is saved when the VISIC100SF is
restarted.
Press “Reset” to restart, see “Measuring unit - circuit board with display and keypad”,
page 17.
RUN
X
XXX
Set
SET
Maint
Esc
Set
>
>
MB ID
Esc
Set
2 s
Even
>
>
... ...
SET
Bus
Set
Esc
>
>
MB Par
Odd
>
>
Set
No 2 SB
Set
No 1 SB
>
>
Set
>
>
SET
SET
SET
SET
SET
SET