SICK VISIC100SF - 10 Specifications; Compliances; Electrical Protection; Standards Observed

97
8017171/115Z/V3-0/2019-01/ SICK OPERATING INSTRUCTIONS | VISIC100SF
Subject to change without notice
SPECIFICATIONS
10 Specifications
10.1 Compliances
● VISIC100SF
The technical design of the device corresponds to the following EC Directive:
– Directive 2004/108/EC (EMC Guideline)
Applied EN standards:
– EN 61326, Electrical equipment for measurement, control and laboratory use - EMC
requirements
● Terminal Box / TAD control unit
The technical design of the device corresponds to the following EC Directive:
– Directive 2006/95/EC (Low Voltage Directive)
Applied EN standards:
– EN 61010-1, Safety requirements for electrical equipment for measurement, control
and laboratory use
10.1.1 Electrical protection
● Insulation: Protection class 1 according to EN 61140.
● Insulation coordination: Overvoltage category II in accordance with EN 61010-1.
● Contamination: The device operates safely in an environment up to contamination level
2 according to EN 61010-1.
10.1.2 Standards observed
● RABT German “Regulations governing equipping and operating road tunnels”
● ASTRA German “Ventilation of road tunnels”
● RVS German “Standards and regulations for road traffic”
● EN 50545
● EN 50271
10.1.3 Declaration of Conformity
● CE