70
8017171/115Z/V3-0/2019-01| SICKO P E R A T I N G I N S T R U C T I O N S | VISIC100SF
Subject to change without notice
MENU NAVIGATION TAD CONTROL UNIT
6.5 Starting operation
6.5.1 Initialization phase
After the power supply is switched on, the display unit performs the initialization phase.
Fig. 56: Display contents during the initialization phase
Changing the display mode
“Wait for communication” is shown on the display at the end of the initialization phase. The
display mode is preset and must be Remote 1. Otherwise it must be changed accordingly.
▸ Press the “Mode” button for three seconds to change the settings.
Fig. 57: “Wait for communication” display text
POWER
FAILURE
MAINTENANCE
REQUEST
MEAS
Mode: Remote 1
Booting
9172014 #YBR3
1Display mode
2Process
3Software version number
POWER
FAILURE
MAINTENANCE
REQUEST
MEAS
Mode
Mode: Remote 1
Wait for
communication
9172014 #YBR3
To Next Page
Loading...
