8 FAULT DIAGNOSIS
8026362 / V1-0/2022-03|SICK
SUPPLEMENTARY OPERATING INSTRUCTIONS | VMS4100/5100
Subject to change without notice
8.3 Detailed fault analysis
The SIM2000-2 Prime controller outputs faults in a staggered manner in messages.
This means that a more detailed analysis is always possible.
• Communication errors can, for example, occur when transmitting telegrams to the
SIM2000-2 Prime controller. The SIM2000-2 Prime controller then returns a fault code.
• For faults that occur during measuring or reading, fault codes are written to a
status log.
The status log distinguishes between four message types:
• Information
• Warning
• Error
• Critical fault
The system saves only the last five entries for each message type.
Information and Warning messages are deleted after a restart.
▸
Call up the status log using the SOPAS configuration software.
▸
To do this, install SOPAS on a computer and connect the computer to the via Ethernet.
NOTE! Please contact SICK Support for a more detailed analysis of the fault situation.
Message types
Calling up the
status log
To Next Page
Loading...
