Installation
88/214 Revision 06 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DB10 • 864-5091.9
➭ Undo 11 bolt-and-washer assemblies M8x40 and 1 hexagonal bolt (with plain washer and
spring washer) at the cover of the panel connection housing ④ .
➭ Remove the panel connection housing ⑤ .
➭ Take the sealing ring ⑥ out of the groove in the cover of the panel connection housing.
➭ Remove 4 pan-head bolts, 4 nuts and 4 strain washers from the cover of the panel
connection housing ⑦ .
➭ Remove the cover of the panel connection housing ⑦ .
Fig. 91: Removing the cover of the panel connection housing
Fig. 89: Removing the cover with the plug sockets
④
Cover of panel connection housing
Fig. 90: Removing the panel
connection housing
④
Cover of panel connection housing
⑤
Panel connection housing
⑥
Sealing ring
NOTE
Do not reuse the removed pan-head bolts, strain washers and nuts.
➭ Dispose of the pan-head bolts, strain washers and nuts in an environmentally
compatible way.
To Next Page
Loading...
