Siemens CP-8000

Installation and Circuitry
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual Unrestricted 173
DC8-037-2.02, Edition 10.2017
6.3 Installation Location and Position
CP-8000/CP-802x is designed for the installation in a cabinet, rack or on the wall.
For details on the subject of environmental conditions, please refer to chapter 4, Ambient
Conditions.
CP-8000/CP-802x may only be installed horizontally.
horizontal mounting position vertical mounting position
Note
Not permitted is the vertical installation or installations on the ceiling and on the floor (excessive tempera-
ture, dust load).
6.3.1 DIN Rail (TS35 Rail)
For the installation of CP-8000/CP-802x a DIN rail is to be used, which conforms to the Euro-
pean Standard IEC 60715. The orientation and position in which the DIN rail is to be installed
must be determined locally.
The DIN rail must be installed horizontally on a vertical wall.
Warning
The connection of the DIN rail with the cabinet/rack must guarantee a reliable grounding of the device.
The cabinet/rack itself must be grounded properly. A mounting plate is recommended.
SICAM CMICSICAM CMIC
P O K R Y E R
E T H
L K 1 P K 1
R S - 23 2
O H 2 R TX 2
R S - 48 5
O H 3 R TX 3
E T H
L K 4 P K 4
S D
X4
SICAMCMIC
F4F3F 2F1
E S C ME NU
SICAM A800 0 CP-8000
Ma in m e nu De v ic e in f or m a t io n Al a rm s Mo n it o r in g
1.0
Co n f i
g
u r a t io n
P OK
RY
ER
ETH
L K1
P K1
RS-2 32
OH2
RTX2
RS-4 85
OH3
RTX3
ETH
L K4
P K4
SD
X4
SICAM CMIC
F4F3F2F1
ESC MENU
SI CA M A8000 CP- 8000
Main menu
Device inform ation
Alar ms
Monitorin
g
1.0
Configuration
X3
RTX3
SICAMA8000 CP-8021
LK1
ETH
X1
PK1
LK4
ETH
X4
PK4
OH2
OH3
RS-2 32
X2
RS-48 5
RTX2
RY ER
SICAMA8000 PS-8620
RY ER
-
+
X1
X3
RTX3 SICAMA8000 CP-8021
L K1 ET H X1 PK1 L K4 ET H X4 PK4 OH2
OH3
RS-2 32 X2
RS-4 85
RTX 2
RY ER
SICAMA8000 PS-8620
RY ER
- +
X1