Engineering via SICAM WEB
SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual Unrestricted 313
DC8-037-2.02, Edition 10.2017
9.1.1.2 Logoff
If you want to finish your work you should log out.
• Click the button and then the submenu Logout
Thus, you are logged out again, the Logon dialog will appear. If a connection via GPRS is
used, the Logon dialog will appear at the latest after 20 seconds.
If you made any changes after the last saving, the following dialog will appear after clicking
Logout:
• If you click , changed data will not be saved and the logout will be performed
• If you click , you remain logged on and you can save the data
Note
The session will be closed by the web server after 15 minutes of inactivity. In this case you have to logon
again. This applies also in case of an unwanted abortion of the communication connection (failure, closing
of the web browser, etc.).
9.1.2 Basic Settings
• Menu Home | Settings
After the initial logon you should define some basic settings for working with SICAM WEB.
The basic settings are necessary to logon to the target device and security
• Authentication procedure
• Change web server password
• Set IP addresses
• Enable optional “Autoconfiguration”
To Next Page
Loading...
