Installation and Circuitry
190 Unrestricted SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
6.5.3 Removal/Shifting of the Master Module
To remove CP-802x again or to change its position on the DIN rail, the locking hooks must be
opened again.
Insert a screwdriver suitable for
slotted screws into the locking
hook (as shown in the picture).
The screw driver must have con-
tact to the housing. The locking
hooks are opened by carefully
pushing the screwdriver down-
wards j resp. upwards k.
When the locking hooks are
locked on the housing you can
pull the module off forward.
Note
If external I/O Modules are coupled to your device, then you can only remove the device after separating
the external I/O Modules.
To Next Page
Loading...
