Engineering via SICAM TOOLBOX II
288 Unrestricted SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
8.1.2.3 Change Password
As user name admin you can define a password for each newly added user.
Guidelines for the Assignment of Passwords
• The password may consist of up to 8 characters
• No differentiation between upper case and lower case
• Special characters can be used
• Empty password possible (logon to the project without password)
Note
The preset password must be changed after the first logon.
8.1.3 Plant Configuration
A plant is configured according to different perspectives:
• Project technique
• System technique
• Process technique
The configuration data is in each case specifically parameterized for the different views.
With the initial creation of a plant you must enter the configuration data into the SICAM
TOOLBOX II with the tool "OPM II". The entry of the parameters is thereby supported by
"Wizards". The plant topology is determined based on the parameter setting of the configura-
tion data.
After the initialization, the administration of the plant configuration can be carried out with the
tool "Plant Management". With this tool the configuration data can be changed or deleted at
any time.
You find the details thereto in the SICAM TOOLBOX II Online Help, chapter "Plant Manage-
ment".
8.1.4 Import Firmware
For the parameterization of a target device the system elements to be used must be
equipped, and the belonging firmwares must be present in the SICAM TOOLBOX II.
You can import the required firmwares – if not yet present – into the data base of the SICAM
TOOLBOX II with the tool “Master Data Update”. You find further information in section
11.5.1.2, Importing Master Data into the SICAM TOOLBOX II.
You find information on firmware files in section 7.3, Loadable Firmwares.
To Next Page
Loading...
