Siemens CP-8000 User Manual

Preparing the Engineering
250 Unrestricted SICAM A8000 / CP-8000 • CP-8021 • CP-8022 Manual
DC8-037-2.02, Edition 10.2017
7.7 Connecting Engineering PC with the Target Device
7.7.1 SICAM TOOLBOX II
Before parameters can be loaded via the SICAM TOOLBOX II into CP-8000/CP-802x, the fol-
lowing steps must be performed:
• Insert a suitable SD card into the target device (if not present)
• Store required TBII updates in the SICAM TOOLBOX II
• Switch on the target device
• Set up physical connection with the target device
The following connection options are available:
• Serial point-to-point connection
• Serial connection via telecommunication facilities
• LAN/WAN connection via Ethernet interface
• LAN/WAN connection via serial interface and Terminalserver
• Connection via further automation unit(s)

Siemens CP-8000 Specifications

General

Product type designation	CP-8000
Category	Controller
Supply voltage	24 V DC
Power Supply	24 V DC (typically with a range of 20.4 to 28.8 V DC)
Protection Class	IP20
Type	Programmable Logic Controller (PLC)
Programming Languages	IEC 61131-3 (Ladder Diagram, Function Block Diagram, Structured Text, Instruction List, Sequential Function Chart)
Operating Temperature	0 to +50 °C (32 to 122 °F)
Storage Temperature	-25 to +70 °C (-13 to +158 °F)
Relative Humidity	5 to 95% (non-condensing)