Siemens CU240S DP-F

To Next Page

To Previous Page

Table of contents

Control Units CU240S

Operating Instructions, 11/2006, A5E00766042B AA

Table 7-5 Parameter accessing error numbers ....................................................................................... 7-12

Table 8-1 Parameter P0700....................................................................................................................... 8-1

Table 8-2 Parameter P1000....................................................................................................................... 8-2

Table 8-3 Binectors .................................................................................................................................... 8-3

Table 8-4 Connectors................................................................................................................................. 8-5

Table 8-5 Possible settings of the digital inputs and analog inputs used as digital inputs ...................... 8-14

Table 8-6 Parameters P0731 to P0733 (frequently used functions/states) ............................................. 8-17

Table 8-7 Pre-set analog outputs............................................................................................................. 8-20

Table 8-8 Max. number of devices and max. cable length ...................................................................... 8-23

Table 8-9 Length of start delay ................................................................................................................ 8-24

Table 8-10 Request identifier (master → inverter)...................................................................................... 8-29

Table 8-11 Response identifier (inverter → master) ................................................................................... 8-29

Table 8-12 Fault numbers for "Cannot process request" response........................................................... 8-30

Table 8-13 Regulation for setting the PNU ................................................................................................ 8-31

Table 8-14 Example coding for parameter no. in PKE and IND for P8820, Index 16................................ 8-32

Table 8-15 Character run time ................................................................................................................... 8-34

Table 8-16 Example of direct selection using digital inputs ....................................................................... 8-38

Table 8-17 Example of binary-coding using digital inputs.......................................................................... 8-39

Table 8-18 Redefined digital inputs............................................................................................................ 8-42

Table 8-19 BICO Connections ................................................................................................................... 8-42

Table 8-20 MOP modes of operation.........................................................................................................8-49

Table 8-21 Correspondence between the parameters .............................................................................. 8-54

Table 8-22 Example of direct selection using digital inputs ....................................................................... 8-55

Table 8-23 Example of binary-coding using digital inputs.......................................................................... 8-56

Table 8-24 Important parameters for PID dancer roll control..................................................................... 8-58

Table 8-25 BICO parameters for ramp-function generator ........................................................................ 8-63

Table 8-26 Examples of settings of parameter P0810............................................................................... 8-67

Table 8-27 Possible settings for parameters P0700 and P1000................................................................ 8-68

Table 8-28 Free function blocks................................................................................................................. 8-69

Table 8-29 Automatic restart...................................................................................................................... 8-94

Table 8-30 Settings for parameter P1200.................................................................................................. 8-96

Table 8-31 Extract of monitoring functions and messages...................................................................... 8-146

Table 8-32 Extract from IEC85 thermal classes ...................................................................................... 8-152

Table 8-33 V/f characteristics (parameter P1300) ................................................................................... 8-162

Table 8-34 Voltage boost ......................................................................................................................... 8-164

Table 8-35 Vector control versions .......................................................................................................... 8-171