Siemens CU240S DP-F - Page 254

Functions
8.12 PID Controller
Control Units CU240S
8-58 Operating Instructions, 11/2006, A5E00766042B AA
Table 8-24 Important parameters for PID dancer roll control
Parameter Parameter text Setting Meaning
1024 Fixed setpoint (FF)
1050 MOP
755.0 Analog input 0
2015.1 USS on RS232
2018.1 USS on RS485
P1070 CI: Main setpoint
2050.1 Fieldbus
1.0 PID controller always active P2200 BI: Enable PID controller
722.x Digital input x
P2251 PID mode 1 PID as trim
1024 Fixed setpoint (FF)
1050 MOP
755.0 Analog input 0
2015.1 USS on RS232
2018.1 USS on RS485
P2253 CI: PID setpoint
2050.1 Fieldbus
755.0 Analog input 0 P2264 CI: PID feedback
755.1 Analog input 1