Siemens CU240S DP-F - Page 51

Installing/Mounting
4.3 Connecting a CU240S DP or CU240S DP-F via PROFIBUS DP
Control Units CU240S
Operating Instructions, 11/2006, A5E00766042B AA
4-13
Bus connector
To connect the PROFIBUS cable to the PROFIBUS DP interface, a bus connector of one of
the types described in the following table is recommended.
Table 4-4 Recommended PROFIBUS connectors
Order Number 6GK1 500-0FC00 6GK1 500-0EA02
PG socket No No
Max. baud rate 12 Mbaud 12 Mbaud
Terminating resistor On/Off switch On/Off switch
Outgoing cable unit 180° 180°
Interfaces
PROFIBUS nodes
PROFIBUS bus cable
9-pin sub D socket
4 modular terminals for wires up
to 1.5 mm
2
9-pin sub D socket
4 modular terminals for wires up
to 1.5 mm
2
Connectable PROFIBUS cable
diameter
8 ± 0.5 mm 8 ± 0.5 mm
Note
We recommend only these two connectors since they can be used without difficulty for all
SINAMICS G120 models and are completely compatible in terms of outgoing cable unit
angle.