DCA Vantage Operator’s Guide 123
Troubleshooting
Operator ID is already in use.
Perform A/C High control test.
Perform HbA1c Normal control test.
Perform A/C Low control test.
Perform an Optical Test.
Perform HbA1c Abnormal control test.
Processing restricted, not ready for
current command.
Remote command received to lockout
patient testing.
Requested data was not found. The values you searched for are not in
the system.
Serial Number is not defined. Contact
your technical support provider.
The serial number for your system is
not in the system software.
Test cancelled due to cartridge load
timeout.
The test was not started within the
time limit.
The access code entered is not valid
or access is denied. Please check
with your supervisor.
The activation key entered does not
match any feature.
The key code you entered is not
correct.
The database was corrupt and
recovered from the system backup.
Some data may be lost.
The Door is open, to continue close
the door.
The cartridge door was opened. The
system will not continue processing
tests until the door is securely closed.
The motor must be homed. Run the
Motor Control Test.
The system door was open during the
test.
During a patient, control, or QC test,
the cartridge door was opened. Close
the door.
The system is in diagnostics mode.
The system is warming up. The system was powered on or power
save mode was active.
This field must have at least one
alphanumeric character.
System Message Comment
To Next Page
Loading...
