72 DCA Vantage Operator’s Guide
Operating the System
Results of a Microalbumin/Creatinine Test
The system displays the following information for each patient Microalbumin/
Creatinine test.
NOTE: You have to enable some of the features in System Settings for the
data to display.
Result Description
System Serial Number
The serial number of the DCA Vantage
system.
Test Name
The type of test, either Microalbumin/
Creatinine test or HbA
1c
test.
Sample Sequence Number The sample sequence number.
Transmission Status The transmission status of the record.
Sample ID
The sample ID, if you entered one into
the system.
Cartridge Lot Number The lot number of the cartridge.
Test Cartridge Scan Date and Time
The date and time the test cartridge
was scanned.
Patient ID
The patient ID, if you entered one into
the system.
Patient Last Name
The last name of the patient, if you
entered one into the system.
Patient First Name
The first name of the patient, if you
entered one into the system.
Operator ID
The Operator ID, if you entered one into
the system.
Comment 1–8
Any comments you entered regarding
the patient.
Glomerular Filtration Rate (GFR)
and input data items
The GFR calculated measurement
based upon data input. The GFR is
displayed if calculated. Refer to
Configuring GFR for a Patient‚ page 81.
Albumin concentration results
The albumin concentration results
display in units of mg/L.
Creatinine concentration results
The creatinine concentration results
display in mg/dL or mmol/L.
To Next Page
Loading...
