DCA Vantage Operator’s Guide 165
a. Use the keypad to enter up to 24 characters for the first header line.
b. Select Enter to save this line.
6. If you want a second header line, select
Line 2.
a. Use the keypad to enter up to 24 characters for the second header line.
b. Select
Enter to save this line.
7. Select
Back to return to the Printers screen.
NOTE: If you reset the printer defaults, the report headers are deleted.
Setting the Printed Patient Test Report Type
Specify whether you want full (long) or short (partial) reports by performing the
following steps. For a summary of the contents of each report format, see
Patient Test Report Contents‚ page 183:
1. At the Home screen, select
System Settings.
2. At the System Settings menu, select
Additional Settings.
3. At the Additional Settings
menu, select Printers.
4. Select
Report Type.
5. Select
Full Report or Short Report.
6. Select
Save to return to the Printers screen.
NOTE: Before attempting to print, make sure that at least one printer is
enabled.
To Next Page
Loading...
