DCA Vantage Operator’s Guide 163
Customizing the System
Customizing the System
5. Select Sequence Number.
6. Select a sequence number reset:
• Resets Daily – the sequence number is reset daily
• Resets after 999 – the sequence number resets after it reaches 999
• None – no sequence number is set
7. To save the sequence number setting, select
Save.
Volume and Display
Use the System Settings menu to access screens to configure the sound
volume and display contrast and brightness.
Setting the Sound Volume
Use the Sound Volume setting to set the volume of the audible alerts.
1. At the Home screen, select Menu.
2. Select
System Settings from the Menu screen.
3. At the System menu, select
System Settings.
4. Select
Sound Volume.
5. Select one of the following options:
• High
• Medium
• Low
•Off
6. Select Save.
The sound volume is set.
Setting the System Display
Use the System Display screen to set the contrast of the color display.
1. At the Home screen, select
Menu.
CAUTION
If you are using a RAPIDComm
®
data management
system, you
must enable sequence numbers so that RAPIDComm can detect
duplicate transmissions. Failure to do so can result in a patient
result record being sent to the Laboratory or Hospital Information
System more than once.
To Next Page
Loading...
