DCA Vantage Operator’s Guide 97
Maintenance
Cleaning the External Barcode Reader Window
To clean the external barcode reader window, follow the manufacturer’s
instructions.
Cleaning the Exterior
Materials Required:
• lint-free cloth
• water or ethanol
1. Clean the exterior with a lint-free cloth dampened with water or ethanol.
2. Connect the power cord after the exterior is clean and dry.
NOTE: If you want to disinfect the exterior of the system, expose the surface to
0.5% sodium hypochlorite for 10 minutes. Remove any liquid blood on the
system before disinfection.
WARNING
Turn the power off and disconnect the power cord before cleaning
the exterior of the system.
CAUTION
Do not allow liquid to drip into system. If liquid drips into the system,
you can damage the optics.
CAUTION
Do not use any other type of solvent, oil, grease, or silicone spray on
any part of the system.
To Next Page
Loading...
