Siemens DCA Vantage - Setting the Host Name; Setting the IP Address to Automatic or Static Mode; Setting the IP Address

DCA Vantage Operator’s Guide 35
Installation
3. At the Additional Settings menu, select Connectivity.
4. Select
Ethernet.
5. Select
POCT1A or ASTM.
The default is POCT1A.
6. Select
Configure to continue setting Ethernet Port options.
Setting the Host Name
Use the Host Name screen to enter the alphanumeric name used to identify
the DCA Vantage system on the network.
1. At the Ethernet Port screen, select Host Name.
2. Use the alphanumeric keypad to enter the host name.
3. Select
Save to save the Host Name information.
The Ethernet Port menu displays.
Setting the IP Address to Automatic or Static Mode
You can configure the system with either Automatic or Static IP settings. If you
select Automatic IP Setting, IP Address, Subnet Mask, and Default Gateway
selections are unavailable.
If you are using Static IP, you must configure the following settings:
• IP Address
• Subnet Mask
• Domain Name Server
• Default Gateway
• Remote Computer
1. At the Ethernet Port menu, select
Automatic IP Setting or Static IP Setting.
The default is Automatic IP.
2. To save the IP setting, select
Save.
The Ethernet Port menu displays.
Setting the IP Address
If you are using Static IP, use the IP Address screen to enter the static IP
address for the Ethernet port.
1. At the Ethernet Port menu, select
IP Address.
2. Use the alphanumeric keypad to enter the IP address.
3. To save the IP address, select
Save.
The Ethernet Port menu displays.