82 DCA Vantage Operator’s Guide
Operating the System
Patient Trend Graph Report
The printed Patient Trend Graph Report prints from the Data Recall menu to
an external printer. To print a graph, you must have an external printer
connected to the DCA Vantage system. For a description of the contents of
this report, see Patient Trend Graph Report Contents‚ page 185.
Control Test Report
The Control Test Report prints the results for Control Tests generated during
analysis, and displays at the Results screen. For a description of the contents
of this report, see Control Test Report‚ page 186.
NOTE: The patient printed test report has no effect on the Control Test Report.
Calibration Data Report
The Calibration Data Report prints the results generated when the HbA
1c
and
Microalbumin/Creatinine cards are scanned into the system. The report prints
the lot number, date and time that the calibration cards were scanned. The
printed reports for a single cartridge scan are generated when you select print
when you scan. Calibration Data Reports for all the calibration data stored on
the system print when a request is issued at Data Recall.
NOTE: Select Print after scanning the calibration card to print the calibration
data report.
Viewing and Printing System Settings Reports
The View System Settings option lets you display and print a partial list of the
configuration settings for the system. The printed partial System Settings
Report contains the same subset of the system settings that appears on the
View System Settings screen.
From the Additional Settings screen, you can print a full System Settings
Report by selecting
Print at the bottom of the screen. The full System Settings
report contains all of the configuration settings for the system.
For a list of the contents of the full and short System Settings Report, see
System Settings Report‚ page 188.
To Next Page
Loading...
