Siemens DCA Vantage - Setting Stop Bits; Resetting Serial Port Options to Default; Setting up the Ethernet Port

34 DCA Vantage Operator’s Guide
Installation
3. Select a string length for the data bits:
•8
•7
The default value is 8.
4. To save the parity settings, select Save.
The Serial Port menu displays.
Setting Stop Bits
1. Select Stop Bits to set the number of stop bits.
2. Select a stop bit length:
•1
•2
The default value is 1.
3. To save the Stop Bits settings, select
Save.
The Serial Port menu displays.
4. Select
Back to return to the Connectivity screen.
5. Select
Save to save the Connectivity settings.
Resetting Serial Port Options to Default
To reset the Serial Port options to the factory default settings:
1. At the Home screen, select
System Settings.
2. At System Settings, select
Additional Settings.
The Additional Settings menu displays.
3. At the Additional Settings menu, select
Connectivity.
4. Select Serial.
ASTM automatically selects.
5. Select
Configure.
6. Select
Reset Defaults.
Setting up the Ethernet Port
Use the Ethernet Port menu to access the system setting to configure
Ethernet communication.
Use the Connectivity menu to enable and disable the Ethernet port. You can
access the screen to select different options for the Ethernet port.
NOTE: The default setting for the Ethernet port is disabled.
1. At the Home screen, select
System Settings.
2. At the System Settings menu, select
Additional Settings.