DCA Vantage Operator’s Guide 31
Installation
Setting up the Report Header
For information about setting up the optional report header, see Customizing
Printed Report Headers‚ page 164.
Setting up the Report Type
For information about setting the optional report type, see Setting the Printed
Patient Test Report Type‚ page 165.
Resetting Printer to Default
1. At the Home screen, select
System Settings.
2. At the System Settings menu, select
Additional Settings.
3. At the Additional Settings
menu, select Printers.
4. Select
Reset Printer Defaults to restore the default printer settings.
This also deletes any report header text you have created.
Loading Paper in the Onboard Printer
Install a roll of printer paper for the onboard printer and reinstall the printer
cover. Refer to Loading Paper on the Onboard Printer‚ page 111.
The printer stops printing when it runs out of paper. If no paper is available at
the start of printing, the printer does not attempt to print.
Software Setup
After the system is properly installed, start the DCA Vantage system by
toggling the power button to the On position. The system displays the
following information:
• Model Name
• System Software Version
• Copyright Information
Start Up Tests
After you turn the power on, a message displays explaining that the system is
starting up. The DCA Vantage system verifies that the compartment door is
closed and performs hardware functionality tests to verify that the internal
optics and the mechanical system are operating correctly.
CAUTION
Do not turn the system off while it is starting up, this can cause
corruption to the stored data.
To Next Page
Loading...
