DCA Vantage Operator’s Guide 94
Quality Control
Quality Control
6. At the Control Test Reminder screen, select 1 of the following:
•HbA
1c
Normal
•HbA
1c
Abnormal
• A/C Low
• A/C High
Once selected, the Schedule button to the right of the control test selected
becomes active.
7. Select
Schedule for the selected test.
8. Select
Change.
9. Select
Optional or Required, and then select Next.
10. Select
Custom.
A screen displays that enables you to select a number between 7 and 60
by pressing up or down arrow keys. The selected number displays above
the arrow keys. The default value is 14.
Both up and down arrow keys cycle continuously through the 7 to 60
number range. For example, if 7 displays, pressing the down arrow key
displays 60. Press the down arrow again to display 59, then 58, and so on.
11. Press an arrow key until the number you want displays.
12. Select
Next.
13. Select the time in hours and minutes, using the arrow keys.
14. Select
AM or PM.
15. Select
Next.
The Settings screen displays. Verify the settings you entered are correct. If
a setting is incorrect, select
Change, and update the settings, as needed.
16. Select
Save.
The Control Test Reminders screen displays.
17. Repeat steps 6 to 16 to set additional QC reminders, as needed.
To Next Page
Loading...
