Siemens FC300 - Page 130

Numeric parameters edit view
Numeric parameters in edit view are displayed as shown here.
6
3
1
2
7
5
8
4
① Parameter name
② Parameter item number
③ Maximum value
④ Escape without saving (frame around ESC is only shown when cursor is in left-most position)
⑤ Confirm and save (frame around OK is only shown when cursor is in right-most position)
⑥ Value to be edited
⑦ Minimum value
⑧ Help text describing the parameter function. The help text appears if no key is pressed for three
seconds.
Figure 7-6 Numeric parameter edit view
Note
##### signs in display
The display is unable to show the measured value. Change the measurement unit or the
resolution.
Changing a value:
1. Select the digit to be changed by pressing and keys.
2. Use key to increase the value and key and decrease the values.
3. Press key in the rightmost position to confirm the changes, or press key in the leftmost
position to escape the view without changing the value.
Note
Ensure that the new value is within the minimum/maximum range.
Changing the resolution:
1. Select decimal point by pressing and keys.
2. Move decimal point by pressing key (moves decimal point to the left) or key (moves
decimal point to the right).
Operating MASS 2100/FC300 with FCT030
7.2 Operating instructions
MASS 2100 & FC300 (FCT030)
130 Operating Instructions, 06/2017, A5E39789040-AA