In order to change the resolution of the process value shown in the operation view (for example
massflow), change the resolution of one configuration parameter for this process value (for
example "Low Flow Cut-off" (menu item 2.2.1.2)). Any changes in resolution will change the
resolution of all configuration parameters for this process value as well.
The resolution can also be changed by setting the decimal places parameter for the selected
process value, for example the decimal places for process value Massflow is defined in
parameter menu item 2.2.1.8.
Numeric parameter read only view
Numeric parameters in read only view are displayed as shown here.
① Escape
② The set value
③ Parameter name
④ Parameter item number
⑤ Help text describing the parameter function.
Figure 7-7 Numeric parameter read only view
The read only view is shown if you don't have access to edit parameters. The view shows the
set value. Press
to escape the view.
Operating MASS 2100/FC300 with FCT030
7.2 Operating instructions
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 131
To Next Page
Loading...
