ID/
Icons
Diagnostic Action Comments
50 Malfunction in Pickup Amplitude Contact your local Siemens representative
51 Malfunction in Pickup Amplitude Contact your local Siemens representative
55 Malfunction in sensor driver Contact your local Siemens representative
56 Malfunction in sensor driver Contact your local Siemens representative
57 Malfunction in sensor driver Contact your local Siemens representative
58 Unstable driver oscillation Contact your local Siemens representative
59 Massflow out of specification Reduce the flow. If the failure continues then
contact your local Siemens representative
60 Volume flow out of specification Reduce the flow. If the failure continues then
contact your local Siemens representative
61 Density out of specification Contact your local Siemens representative
Diagnosing and troubleshooting
10.2 Fault codes and corrective actions
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 191
To Next Page
Loading...
