Siemens FC300 - Page 281

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
2.2.8.3 Measurement Mode Mass or fraction table is selected Massflow
● Massflow
● Volumeflow
Read
only
2.2.7.2 Units Select unit for displayed fraction
volume flow rate. Unit is not ap‐
plied at communication inter‐
face.
m
3
/h l/s, l/min, l/h, l/ d,
Ml/d, hl/s, hl/ min,
hl/h, hl/d, m
3
//s,
m
3
/min, m
3
/h, m
3
/
d, Mm
3
/d, gal/s
(US), gal/min
(US), gal/h (US),
gal/d (US), Mgal/
d, gal/s (UK), gal/
min (Uk), gal/h
(UK), gal/d (UK),
bbl-beer/s, bbl-
beer/min, bbl-
beer/h, bbl-beer/
d, kbbl/d, Mbbl/d,
bbl (US)/s, bbl
(US)/min, bbl
(US)/h, bbl (US)/
d, ft
3
/s, ft
3
/min, ft
3
/
h, ft
3
/d, Mft
3
/d, af/
min, af/h, af/d, in
3
/
s, in
3
/min, in
3
/h,
in
3
/d, yd3/s, yd
3
/
min, yd
3
/h, yd
3
/d,
bu/s, bu/min, bu/
h, bu/d, Custom
User
2.2.7.4 Fraction Name Name of the selected fraction or
concentration of two-part mix‐
tures or solutions.
Read
Only
2.2.7.5 Fraction A
2.2.7.5.1 Fraction A Text Enter a text to describe the Frac‐
tion A.
User
2.2.7.5.2 Upper Limit Alarm Set upper alarm limit. Alarm is
triggered if fraction A value is
above the limit.
1) 1)
User
2.2.7.5.3 Upper Limit Warning Set upper warning limit. Warning
is triggered if fraction A value is
above the limit.
1) 1)
User
2.2.7.5.4 Lower Limit Warning Set lower warning limit. Warning
is triggered if fraction A value is
below the limit.
1) 1)
User
2.2.7.5.5 Lower Limit Alarm Set lower alarm limit. Alarm is
triggered if fraction A value is be‐
low the limit.
1) 1)
User
2.2.7.5.6 Alarm Hysteresis Enter the hysteresis to avoid un‐
wanted rapid switching.
1) 1)
User
Default settings
B.3 Standard volume flow
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 281