Siemens FC300 - Page 282

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
2.2.7.5.7 Decimal Places Define the decimal point for the
process value displayed in the
Local User Interface.
2
● Auto
● No decimal
place
● 1
● 2
● 3
● 4
● 5
● 6
User
2.2.7.6 Fraction B
2.2.7.6.1 Fraction B Text Enter a text to describe the Frac‐
tion B.
User
2.2.7.6.2 Upper Limit Alarm Set upper alarm limit. Alarm is
displayed if fraction B value is
above the limit.
1) 1)
User
2.2.7.6.3 Upper Limit Warning Set upper warning limit. Warning
is triggered displayed if fraction
B value is above the limit.
1) 1)
User
2.2.7.6.4 Lower Limit Warning Set lower warning limit. Warning
is triggered if fraction B value is
below the limit.
1) 1)
User
2.2.7.6.5 Lower Limit Alarm Set lower alarm limit. Alarm is
triggered if fraction B value is be‐
low the limit.
1) 1)
User
2.2.7.6.6 Hysteresis Enter the hysteresis to avoid un‐
wanted rapid switching.
1) 1)
User
2.2.7.6.7 Decimal Places Define the decimal point for the
process value displayed in the
Local User Interface.
2
● Auto
● No decimal
place
● 1
● 2
● 3
● 4
● 5
● 6
User
2.2.7.7 Fraction A %
2.2.7.7.1 Upper Limit Alarm Set upper limit alarm. Alarm is
displayed if fraction A % value is
above the limit.
100
[%]
0.0 to 100.0 User
2.2.7.7.2 Upper Limit Warning Set upper limit warning. Warning
is displayed if fraction A % value
is above the limit.
100
[%]
0.0 to 100.0 User
2.2.7.7.3 Lower Limit Warning Set lower limit warning. Warning
is displayed if fraction A % value
is below the limit.
0
[%]
0.0 to 100.0 User
Default settings
B.3 Standard volume flow
MASS 2100 & FC300 (FCT030)
282 Operating Instructions, 06/2017, A5E39789040-AA