Siemens FC300 - Page 290

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
2.3.3.10.12) Upper alarm limit Set upper alarm limit. Alarm is
triggered if totalizer 3 value is
above the limit.
[m
3
] User
2.3.3.10.22) Upper warning limit Set upper warning limit. Waning
is triggered if totalizer 3 value is
above the limit.
[m
3
] User
2.3.3.10.32) Lower warning limit Set lower alarm limit. Warning is
triggered if totalizer 3 value is
above the limit.
[m
3
] User
2.3.3.10.4 2) Lower alarm limit Set lower warning limit. Alarm is
triggered if totalizer 3 value is
above the limit.
[m
3
] User
2.3.3.10.5 2) Hysteresis Enter the hysteresis to avoid un‐
wanted rapid switching.
0
[m
3
]
User
2.3.3.10.3) Upper alarm limit Set upper alarm limit. Alarm is
triggered if totalizer 3 value is
above the limit.
[normal m
3
] User
2.3.3.10.23) Upper warning limit Set upper warning limit. Waning
is triggered if totalizer 3 value is
above the limit.
[normal m
3
] User
2.3.3.10.33) Lower warning limit Set lower alarm limit. Warning is
triggered if totalizer 3 value is
above the limit.
[normal m
3
] User
2.3.3.10.4
3
) Lower alarm limit Set lower warning limit. Alarm is
triggered if totalizer 3 value is
above the limit.
[normal m
3
] User
2.3.3.10.5
3
) Alarm Hysteresis Sets the hysteresis for alarm
and warning limits. The hystere‐
sis is the distance between the
limits for activation and deactiva‐
tion of an alarm/warning.
0
[normal m
3
]
User
2.3.4 Reset all totalizers Reset totalizer 1, totalizer 2 and
totalizer 3 to zero
Cancel
● Cancel
● Ok
User
1)
Process Value is set to Mass flow
2)
Process Value is set to Volume flow
3)
Process Value is set to Standard volume flow
Default settings
B.4 Totalizer
MASS 2100 & FC300 (FCT030)
290 Operating Instructions, 06/2017, A5E39789040-AA