Siemens FC300 - Page 289

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
2.3.3.4 Custom conversion fac‐
tor
Define a mass factor for the cus‐
tom units. The factor is based on
SI mass units kg
1) 1)
User
2.3.3.5 Decimal Places 1) 2) 3) Define the decimal point for the
process value triggered in the
Local display.
2
● Auto
● No decimal
place
● 1
● 2
● 3
● 4
● 5
● 6
User
2.3.3.6 Direction Select totalizing direction. Forward count‐
ing
● Forward
counting and
backward
counting
● Forward
counting
● Backward
counting
● Hold
User
2.3.3.7 Fail-safe behaviour Select reaction of the totalizer
function in case of unreliable
process flow value.
Run
● Run
● Hold
● Memory
User
2.3.3.9 Preset Reset totalizer 3 to selected pre‐
set value
● Cancel
● Ok
User
2.3.2.10 Alarm and warning limits
2.3.3.10.11) Upper alarm limit Set upper alarm limit. Alarm is
triggered if totalizer 3 value is
above the limit.
[kg] User
2.3.3.10.21) Upper warning limit Set upper warning limit. Waning
is triggered if totalizer 3 value is
above the limit.
[kg] User
2.3.3.10.31) Lower warning limit Set lower alarm limit. Warning is
triggered if totalizer 3 value is
above the limit.
[kg] User
2.3.3.10.4 1) Lower alarm limit Set lower warning limit. Alarm is
triggered if totalizer 3 value is
above the limit.
[kg] User
2.3.3.10.5 1) Hysteresis Sets the hysteresis for alarm
and warning limits. The hystere‐
sis is the distance between the
limits for activation and deactiva‐
tion of an alarm/warning
0
[kg]
User
Default settings
B.4 Totalizer
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 289