Siemens FC300 - Page 363

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
2.4.5.9.3 CH2 forced value Enter the value for the output
signal when forcing is activated.
Frequency / Pulse
1 Hz 0 to 12500 Hz User
2.4.5.9.3 CH2 forced value Enter the value for the output
signal when forcing is activated.
Status
Off
● On
● Off
User
2.4.5.9.4 CH3 forced value Enter the value for the output
signal when forcing is activated.
Current
4.00 mA 3.5 to 25 mA User
2.4.5.9.4 CH3 forced value Enter the value for the output
signal when forcing is activated.
Frequency / Pulse
1 Hz 0 to 12500 Hz User
2.4.5.9.4 CH3 forced value Enter the value for the output
signal when forcing is activated.
Status
Off
● On
● Off
User
2.4.5.9.5 CH4 forced value Enter the value for the output
signal when forcing is activated.
Current
4.00 mA 3.5 to 25 mA User
2.4.5.9.5 CH4 forced value Enter the value for the output
signal when forcing is activated.
Frequency / Pulse
1 Hz 0 to 12500 Hz User
2.4.5.9.5 CH4 forced value Enter the value for the output
signal when forcing is activated.
Status
Off
● On
● Off
User
2.4.5.9.6 Delay time Select debounce time used to fil‐
ter the hardware input signal.
0.0 ms
● 0.0 ms
● 0.5 ms
● 1.0 ms
● 1.5 ms
● 2.0 ms
● 2.5 ms
● 3.0 ms
● 3.5 ms
● 4.0 ms
● 4.5 ms
● 5.0 ms
● 5.5 ms
● 6.0 ms
● 7.0 ms
● 7.5 ms
User
2.4.5.9.7 Polarity Set the level of an active input:
active high or active low.
Active high level
● Active high
level
● Active low
level
Default settings
B.5 Inputs and outputs
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 363