HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.5.4.3 Timestamp at minimum Timestamp at minimum Read
only
3.5.4.4 Maximum Maximum value measured. Read
only
3.5.4.5 Timestamp at maximum Timestamp at maximum Read
only
3.5.4.6 Reset The peak values will be reset to
current values.
User
3.6 Characteristics
3.6.1 SIL variant Specifies whether the device is
allowed to be used in Safety ap‐
plications
Yes or No
● Yes
● No
Read
only
3.6.2 CT variant Specifies whether the device is
allowed to be used in Custody
Transfer applications
Yes or No
● Yes
● No
Read
only
3.6.3 CT active Specifies whether the device is
in Custody Transfer mode
Read
only
3.6.4 Transmitter
3.6.4.1 Design Describes the main design fea‐
ture of the transmitter.
Read
only
3.6.4.2 Hazardous Area Appro‐
val
Describes the hazardous area
approval for the transmitter. The
text can also be found on the la‐
bel of the product.
Read
only
3.6.6 Sensor
3.6.6.1 Hazardous area appro‐
val
Defines gas classes and hazard‐
ous zones applicable for the sen‐
sor.
Read
only
3.6.6.2 Maximum mass flow ca‐
pacity
Maximum mass flow measure‐
ment capacity of the sensor.
[kg/h] Read
only
3.6.6.3 Calibration factor Factory-set calibration factor. Read
only
3.6.6.4 Density calibration offset Factory-set density calibration
offset.
Read
only
3.6.6.5 Density calibration factor Factory-set density calibration
factor.
Read
only
3.6.6.6 Dens. comp. tube temp. Factory-set tube temperature
compensation for density calcu‐
lation.
Read
only
3.6.6.7 Dens. comp. frame
temp.
Factory-set frame temperature
compensation for density calcu‐
lation.
Read
only
3.6.6.8 Wetted materials Type of wetted material of the
sensor.
Read
only
3.6.7 Fraction order code Order code of the active fraction.
Default settings
B.9 Maintenance and diagnostics
MASS 2100 & FC300 (FCT030)
446 Operating Instructions, 06/2017, A5E39789040-AA
To Next Page
Loading...
