Siemens FC300 - Page 447

Table B-37 SensorFlash
HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
3.7.1 Eject Do you want to eject the Sensor‐
Flash?
● Cancel
● OK
User
3.7.2 Installed SensorFlash is installed in the
transmitter. SensorFlash in‐
cludes backup data for transmit‐
ter and sensor.
● SensorFlash
not installed
● SensorFlash
installed
● SensorFlash
used as MSD
Read
only
3.7.3 Capacity total Total capacity of installed Sen‐
sorFlash.
[GB] Read
only
3.7.4 Capacity available Available capacity of installed
SensorFlash.
[GB] Read
only
3.7.5 Data logging
3.7.5.1 Activation The datalogger can only be con‐
figured while it is turned off.
Thus, the configuration menus
are not accessible in on-mode.
Off
● Off
● On
User
3.7.5.2 Data logging mode For information only. Deactive
the datalogger to gain write ac‐
cess.
Log instantane‐
out
● Log
instantaneout
● Log average
value
User
3.7.5.3 Logging interval 5 S
● 10 ms
● 20 ms
● 100 ms
● 500 ms
● 1 s
● 5 s
● 10 s
● 15 s
● 30 s
● 1 min
● 5 min
● 15 min
● 30 min
● 1 h
● 2 h
● 4 h
● 6 h
● 12 h
● 24 h
User
3.7.5.4 Process values
Default settings
B.9 Maintenance and diagnostics
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 447