Siemens FC300 - Page 471

HMI menu ID Parameter Description Default value
[unit]
Value range Access
level
4.2.9.2 Process values (1) Select the process values for
damping
● Mass flow
● Volume flow
● Standard
volume flow
● Standard
density
● Totalizer 1
● Totalizer 2
● Totalizer 3
● Dosing
● Density
● Medium
temperature
User
4.3 Modbus (channel 1)
4.3.1 Slave address (SW) Enter the device Modbus ad‐
dress. HW address device ad‐
dress overwrites the SW device
address.
1 1 to 247 User
4.3.2 Slave address (HW) Hardware device Modbus ad‐
dress. The HW device address
is configured by DIP switch in
the device.
Read
oSLy
4.3.3 Change Modbus param‐
eters
Changing Modbus parameters
needs restart communication
Cancel
● Cancel
● Ok
User
4.3.4 Data rate Select the data rate of your Mod‐
bus network.
19200 Bit/s
● 4800 Bit/s
● 9600 Bit/s
● 38400 Bit/s
● 57600 Bit/s
● 76800 Bit/s
● 115200 Bit/s
User
4.3.5 Parity and framing Select parity and stop bit config‐
uration.
Even parity, 1
stopbit
● Even parity, 1
stopbit
● Odd parity, 1
stopbit
● No parity, 2
stopbits
User
4.3.6 Floating point byte order Select byte transmission se‐
quence
3-2-1-0
● 1-0-3-2
● 0-1-2-3
● 2-3-0-1
● 3-2-1-0
User
Default settings
B.13 Communication
MASS 2100 & FC300 (FCT030)
Operating Instructions, 06/2017, A5E39789040-AA 471