492/617
Building Technologies Division User Manual LMS14… CC1U7471en
6 The settings in detail 28.01.2015
Line no. Operating line
7165 Forced heat draw DHW
Off
On
This parameter allows you to specify that the heat should primarily be conveyed to the
DHW circuit while the chimney sweep function is active.
Off
The heat has to be conveyed to the heating circuits.
On
When the chimney sweep function is active, the heat is primarily conveyed to the DHW
circuit.
Line no. Operating line
7170 Telephone customer service
Setting the phone number that appears on the info display.
Forced heat draw DHW
Telephone customer
service
To Next Page
Loading...
Need help?
General
