Siemens LMV37.4 Series - Page 205

205/267
Building Technologies Basic documentation LMV37.4... CC1P7546en
27 Parameter level 17.12.2018
P
Vh
mi n
s%
Bild 117/0707
Phase Traveling to ignition position
Wait until the burner is operating and symbol ▲ or ▼ is no longer highlighted!
The startup sequence stops in phase 36 Traveling to ignition position.
The ignition point can be adjusted under cold conditions.
F
or
A
and
or
as well as
F
and
A
and
or
P
Vh
mi n
s%
Bild 118/0707
Ignition position P0 can only be set after symbol
▲ or ▼ is no longer highlighted.
For fuel, keep
F
depressed, for air
A
, as
well as for VSD
F
and
A
Press
or to adjust the value.
When symbol ▲ or ▼ is no longer highlighted,
the next curvepoint P1 can be selected with
.
P
Vh
mi n
s%
Bild 117/0707
Phase Traveling to ignition position
P
Vh
mi n
s%
Bild 119/0707
Phase Preignition
P
Vh
mi n
s%
Bild 120/0707
Phase 1st safety time (ignition transformer ON)
P
Vh
mi n
s%
Bild 121/0707
Phase 1st safety time (ignition transformer OFF),
preignition time OFF
P
Vh
mi n
s%
Bild 122/0707
Phase Interval 1