209/267
Building Technologies Basic documentation LMV37.4... CC1P7546en
27 Parameter level 17.12.2018
P
Vhmins%
Bild 94/0707
When symbol ▼ or ▲ is no longer highlighted, you can
press ESC a second time.
ESC
P
Vh
mi n
s%
Bild 128/0707
The warm settings for fuel-air ratio control by the LMV37.4 are now completed.
27.11.5 Warm settings for modulating mode («G mod pneu», «Gp1 mod pneu»
and «Gp2 mod pneu»)
Note
Refer to chapter Warm settings for modulating mode («G mod», «Gp1 mod», «Gp2 mod»
and «Lo mod»)! Here, only the air requires adjustment with
.
27.11.6 Cold settings for «G mod», «Gp1 mod», «Gp2 mod» and «Lo mod»
Note
Refer to chapter Warm settings for modulating mode («G mod», «Gp1 mod», «Gp2 mod»
and «Lo mod»)!
With no flame, however, no actuator travel and no automatic operation after the settings have
been made.
If run is shown in the display, the following must be observed:
P
Vh
mi n
s%
Bild 113/0707
Identification of start for setting the curve.
Note!
You now have the option of pressing
ESC
to continue with the cold setting for
the LMV37.4.
To Next Page
Loading...
Need help?
General
