Siemens SIMATIC ET 200eco PN - Parameter

IO-Link Master
11.2 IO-Link Master (6ES7148-6JD00-0AB0)
ET 200eco PN
Operating Instructions, 08/2016, A5E01250250-AJ
223
11.2.2
Parameter
Port parameters for the IO-Link Master 4 IO-L 4×M12
Parameters
Range of values
Default setting
IO-Link master (for each submodule/port)
Autostart (without S7-PCT)
• Disable
• Enable
Disable
Diag: Port
• Disable
• Enable
Disable
Diag: Missing 2L+
• Disable
• Enable
Disable
Hardware interrupt (device notification)
• Disable
• Enable
Disable
Explanation of the parameters
Autostart (without S7-PCT)
These parameters enable the commissioning of an IO-Link device without using the S7-Port
Configuration Tools (S7-PCT).
This is started automatically (plug-and-play functionality) when an IO-Link device is
connected. The IO-Link device is operational and immediately available to the user.
Note
Changes to the port configuration
If you have a
ssigned the parameters for the IO-Link device via Autostart (without S7-PCT),
or have configured the port as digital input, digital output or disabled, you can no longer
change the port configuration via S7
-PCT.
Diag: Port
Enabling of the diagnostics for the selected port.
A distinction is made between error and maintenance interrupts during the diagnostics. The
possible diagnostics depend IO-Link device used. More information on the diagnostic
interrupts is available in the description of the IO-Link device that is used.
Diag: Missing 2L+
Enabling of diagnostics in the case of missing or insufficient load voltage 2L+.