Siemens SIMATIC ET 200eco PN - Installation with mounting rail; Mounting position, mounting dimensions

Installing
2.2 Installation with mounting rail
ET 200eco PN
24 Operating Instructions, 08/2016, A5E01250250-AJ
2.2
Installation with mounting rail
Version
The mounting rail is available with a length of 500 mm.
Installing the mounting rail
Cut the 500-mm rail to suit your requirements and drill mounting holes for the M8 screws.
You should distribute the mounting holes evenly at a pitch of 182 mm on the rail, starting at a
distance of 12 mm from the edge.
Use the rack screw to bolt the I/O devices onto the mounting rail.
Figure 2-4 Installing the mounting rail
2.3
Mounting position, mounting dimensions
Mounting position
The ET 200eco PN can be mounted in any position.
Mounting and clearance dimensions
Table 2- 1 Mounting dimensions
Dimensions
single width
double width
Mounting width
30 mm
60 mm
Mounting height
200 mm
175 mm
Mounting depth
49 mm
49 mm